My Finished Knee Guards !

Real Scooby

Active Hunter
Finally I found the time to finish up the kneeguards.
I just have to weahter up the elastic a little to match the color of the jumpsuit.

imag0084sy8.th.jpg
imag0085vg8.th.jpg
imag0086iu2.th.jpg
 
Last edited by a moderator:
You've done a real nice job with the weathering so far! How did you secure the elastic straps to the armor? Just velcro or did you use some sort of glue?
 
I hotclued one end "into" the box side since BM´s are semihollow at that area. The clue also helps securing the bolts for the rocketlaunchers. The other side is openable with velcro.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top