Lord Headass' 3d printed Mando Build

Thread starter LordHeadass
Start date Apr 28, 2021
Tags

3d printed din djarin the mandalorian

LordHeadass

New Hunter

Apr 28, 2021

I printed the chest piece and glued it together (that's what the white stuff is on the piece) and the sizing is off by a bit. I was wondering if anyone has any input on how much I could increase the percent of the piece in my 3d printer slicer program for it to fit me. Currently, it's at 100% size in the program and the files are by Great Ape Studio Art on Etsy

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.