How to produce a glossy surface on a prop (Vader helmet improvement)


Active Hunter
Although I'm working on my Boba helmets I thought about buying one of those Darth Vader supreme edition costumes. I think they are not bad, but there could be done some improvement on the helmet's surface. I think it could be more shiny, glossy and less vinyl-looking. Does anybody know how I could get there?:confused
The plastic polish they use on TK armor would probably work great. NOVUS #2
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.