How to create pattern from mandalorian blueprints



I have seen people having a lot of problems trying to print the blueprints the correct size. Here is a very simple method I used:

Resize the blueprints so that when you hold a ruler up to the computer screen it exactly matches the scale.

Use clear plastic (overhead projector plastic) to trace the patterns right off the screen. The pieces won't fit on most mortals' screens, so trace what you can, then scroll and trace the rest.

This method took me a few minutes to create patterns for all the armor pieces.
i had that prob to. it was a pain to get them the correct size. i just figured out what % i wanted to make it bigger and then i just redrew it with the new lengths. it took alot of time but it seemed to work good for me.
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.