Help needed.


New Hunter
I recently bought a stormtrooper helmet and I want to toughen it up. Will there be any problem if I fiberglass the inside of the helmet? It is made of ABS.

Thanks in advance.
No reason why you shouldnt be able to fibreglass the inside (although I'm no expert on ABS) as long as you remember to rough up the surface with some course sand paper so that it has something to cling to (y)
mm.. What he said. roughen the surface up a bit before. you might also want to put a layer of polyester (resin) first and let that dry for a day before you add another layer of the fibreglass/resin mix.
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.