Heavy Infantry Mandalorian

awill08

New Hunter
This is my first Mandalorian and cosplay project. I bought the 3D files from galatic armory. This helmet just came off the printer. I need to clean up it up, paint and print the helmet accents. I bought a few visors from t-visor thanks to this board for the recommendation. Looking forward to finishing this building and attending a Con.

This is the way.
 

Attachments

  • 20210813_230309.jpg
    20210813_230309.jpg
    1.3 MB · Views: 157
  • 20210813_230022.jpg
    20210813_230022.jpg
    1.2 MB · Views: 152
  • 20210813_230016.jpg
    20210813_230016.jpg
    1.2 MB · Views: 156
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top