Grav charges file?

nitro28

nitro28

New Hunter
Is there a preferred STL file for the grave charges that you all use? I would like to make these as accurate as possible by using transparent resin for the bottom portion then PLA for the body. I have found a few files here and there but not sure what you all recommend. I will use a magnet system to attach them. Thanks.
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

alex920a
Aluminium Grav charge with Led & sounds
Replies
7
Views
3,809
SolarFett
SolarFett
SpaceSoap
Most accurate Din Djarin bucket file?
Replies
3
Views
3,595
bobafett22
bobafett22
shenphong
The great Mandalorian 3d file helmet comparison
Replies
17
Views
9,604
Baruopa
Baruopa
Malkavian
Ep1 armor, 3D files or blue prints
Replies
0
Views
925
Malkavian
Malkavian
stormtrooperguy
Keyslots for the Project 842 3d print file
Replies
3
Views
2,421
whistler9981
whistler9981

Similar threads

alex920a
Aluminium Grav charge with Led & sounds
Replies
7
Views
3,809
SolarFett
SolarFett
SpaceSoap
Most accurate Din Djarin bucket file?
Replies
3
Views
3,595
bobafett22
bobafett22
shenphong
The great Mandalorian 3d file helmet comparison
Replies
17
Views
9,604
Baruopa
Baruopa
Malkavian
Ep1 armor, 3D files or blue prints
Replies
0
Views
925
Malkavian
Malkavian
stormtrooperguy
Keyslots for the Project 842 3d print file
Replies
3
Views
2,421
whistler9981
whistler9981
Back
Top