Death Watch "Grapple" Jetpack 3d Model

Thread starter bravoleader
Start date Jun 16, 2016

bravoleader

New Hunter

Jun 16, 2016

Hello Everyone.
I got a commission by a fellow BHG member whom asked me to design a "Grapple" Jetpack. I think I'm the first one that worked on this kind of Jetpack

Here is what I came with.

I believe that I went pretty much close to the original model and I hope you will appreciate that

The model is fully 3D printable and I did a small update on it having made the side tubes little bit longer so you can see the final version in the first picture. the other 2 pictures will show you the overall look but the tanks have the correct size in the first picture.

F

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.