Finished ESB Gauntlets

clmayfield

Active Hunter
Well, with Combat Baby's acrylic nozzle, I am going to call my gauntlets done. I could probably stand to trim my MQ-1 a bit more, but like they say, you are never really done with a Fett.

Gauntlets 1.jpg


Apologies for the lights used to hold the gaunts up...

Gauntlets 2.jpg


...and a closeup of the acrylic nozzle...
Gauntlets - Nozzle.jpg


And credit where credit is due... DVH furnished the paint job. I think he did a great job!
 
I think I can do that. The Expander has a screw in the back that attaches via JB Weld. I will just need to thread another hole below to lower it a bit.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top