Blaster Dying molex connectors?

Boba Flint

New Hunter
I saw a couple of post about dying the molex connectors black, but how they were dyed wasn't in the post.
I've PM the member but it looks like he doesn't come to the site often.

Anyone know how it's done? Or should I just paint them and any recommendations of what paint to use would be appreciated.
 
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top