Cut out my Armor already...

Macantosh 1138

Active Hunter
It's turned out nicely, but I still have to bend the metal and add the dents, I'll post pics later, I figure I'll have the armor done by tonight, but I still have to paint it.
well, almost finished with bending them, I have like one more bend to go, just stopped because I slit two fingers open, nothing bad though, that's the risk you take when you use acual metal for your armor...
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.