Shin Tools Anti-security blade length

MLS

Active Hunter
Tonight I decided to construct a set of shin tools from the paterson parts I've had floating in my shop for a year. Knife was easy, sonic beam was simple, adjustment rod was machined... then the anti-security blade reared its ugly head. The cutoff from my squeegee is 4.25" the 2 machined rods I have are 3" long... and a few pics I've seen have the blade size anywhere from 3.5" (on some templates) and up (on some reference pics). So, someone throw me a bone and shed some light on this for me. Thanks in advance.
 
Last edited by a moderator:
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top