3d Printed Armor - adding dents

pucksdown

Jr Hunter
I am looking ahead to some of my next build.

Has anyone added the dents to 3d printed armor? If so what technique did you use?

Thanks!
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top