Recent content by terminal fettler

Green on L/H ear, bit more weathering to add details will come later...

Grey Layer on left hand ear...

First layer on the ears. Left ear is printed, right ear cast resin. I had to create a concave underside for the left ear to allow it to sit flush as the ear platform has a slight curve to it... All parts have threads tapped into them for fixing with brass cheese head screws...

Final test fit of 3D printed left ear and cast right ear pieces and stalk...

A quick test fit of a 3D printed left ear, just printing another version to try now...

And a HUGE shout out to your templates which are a must go to when painting this colour scheme...

Getting there now, still a lot of small details to add within the damaged areas. Colours are washed out in the lighting on these pictures. Next I will be 3D printing the left ear to fit this helmet...

Never get tired of seeing your excellent work! (y)

Going on with the red on the mandibles and trim!

Here is the purple layer on, still more of this to add within the silver areas of damage, this will go on as a final detail layer after the red, and a few areas of stubborn masking fluid to remove to expose silver and grey...

Finally ready for some more paint...

Just finishing up the next layer of masking, pics to follow shortly...

After too long a break, I am back on this... Just marking out detail on the mandibles and trim for the next layer...

If I recall this helmet was free hand...

Kill Stripes are done except for some minor detail to add later. Managed to capture some of the paint edge detail on the more orange stripes towards the back of the helmet, this was done by layering the colours and then buffing them back slightly with 0000 wire wool... Next onto the mandibles...