Death Watch My Death Watch helmet build

Bogleo

New Hunter
Hi,

Recently I decided to make a Death Watch helmet from Star wars. I couldn't find any free Pepakura files for it, so I decided to model it myself.

Here is the model so far. Screen Shot 2015-01-25 at 2.14.48 PM.pngScreen Shot 2015-01-25 at 2.14.56 PM.pngScreen Shot 2015-01-25 at 2.49.41 PM.pngScreen Shot 2015-01-25 at 3.21.21 PM.pngScreen Shot 2015-01-25 at 3.21.28 PM.pngScreen Shot 2015-01-25 at 4.00.11 PM.pngScreen Shot 2015-01-25 at 4.00.16 PM.pngScreen Shot 2015-01-25 at 4.00.25 PM.png
 
The model is done now. I left the ears off for pepakura because I think it will be easier to assemble.

I printed it and started assembling it on card stock. I put some pics up once I'm a little farther.

I modeled the ears so it is all done now. Here are a couple of renders.

DW render 1.pngDW render 2.pngDW render 3.pngDW render 4.png
 
I'm very concerned that you'll not be able to use the visor to see out of the helmet. It looks way too high up to be practical..!!
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top