HIC panel real size?

haky

New Hunter
I printed my 3d.
There is something wrong happened.
I'm looking for the right size!
Please help!
Thanks!

b3.jpg
 
Ok mesured my casting and from raised bezel edge 4" tall and 13" wide. This is just front raised bezel "rectangle" not the extra flange area.

The back side side is a little awkward to measure widest point 13 3/4". Height 5 1/4" (no tabs), 5 5/8" (with tabs).
Mine is a casting from a mold that I am the 3rd owner of, but it was made from a real Volvo panel, but I am not a taking measurements off of a actual Volvo panel.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top