Seeker's 41st Elite Corps Clone Trooper Armor

Kinda a stupid question, but who makes the Clone Buckets? Great paint schemes by the way! Would love to start a clone suit but unsure who makes the most accurate suit? Clone Six? Any advice welcomed....
 
I tried on a MR. Clone helmet, and it fit me, it really only fit me, and Andy.

these quality helmets (like Seeker's) are great, I would love to find out who makes them asa well.
 
Just out of curiosity, what's the base armor? JM, C6?

My armor will a combitation of my own built parts, clone six, O.s.c.s helmet, and TD1035 rubber belt and boxes.

Kinda a stupid question, but who makes the Clone Buckets? Great paint schemes by the way! Would love to start a clone suit but unsure who makes the most accurate suit? Clone Six? Any advice welcomed....

Helmet - O.S.C.S guys over at clonetrooper.net
Amor - Clone six and JavaMonkey

Thanks again guys. thanks for the feedback.

Turo
 
A little update I started messing around and see if I could make some biceps and shoulders. I noticed that the Episode II clone has bigger shoulders pads then Episode III. So went with the smaller EPIII shoulders.
I had to go in there and photshop the rest of the bicep. My model, I mean my wife's t-shirt got on the way. :D

clonebiceparm.jpg


I also made the ab piece from scratch which goes around the whole back out of sintra. Drilled the ab holes. I cut my belt boxes and glued them to the belt by using WELDER Contact Adhesive. Very strong stuff. I'm still going to add pins to make it stronger. I also reworked the C6 codpiece by reshaping the lines in the end of the tip. This cod is a little to big for me, so I cut alot it from the top which is good, because my belly and cod are separted. These are just try out pics. There not permanently finished yet.
Your thoughts?


cloneproject200.jpg


cloneproject201.jpg


cloneproject202.jpg


cloneproject203.jpg


cloneproject204.jpg


cloneproject205.jpg


cloneproject206.jpg


cloneproject207.jpg


cloneproject208.jpg


cloneproject209.jpg


cloneproject210.jpg


cloneproject211.jpg
 
Last edited by a moderator:
That's purdy!

That is a fine job you are doing there Turo. I really like the belly piece; the detail really looks sharp. I think i will have to try that.
 
I'm glad you explained that 1st photo, I thought you took a black sharpie marker to your wife:lol:

Turo, that clone armor is coming along awesome, thanks for the update!
 
Thanks everyone.

Thank you C6 - your armor looks fantastic. I'm so glad I have a set. I hope you dont mind me reworking some of the parts.:D

I'm hoping to finish it by C4, but I just dont have time. AAARRRRGGGG!!!!!

Me.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top