Pepakura ROTJ Endor Rebel helmet donut

dung0beetle

Active Hunter
I'm filling out my collection of SW pep helmet models. My latest is the donut for the ROTJ Endor Rebel helmet. Some trimming will be needed on the inside edges and possibly the top of the donut, but I modeled them for support while glassing, so they can be removed altogether after most of the fiberglass and bondo work is done. If anyone knows the proper dimensions, I can definitely use the info so I can release the scaled model.
endorreb3.gif

endordonut.gif

I may decide to extend the lower part of the donut into a solid piece like some of the kits I've seen. It may be easier to fit it to the cloth cap.
 
oh my gosh... I was JUST thinking of this exact helmet in pep yesterday... YOU ARE PSYCHIC! Now I gotta figure out the correct style of hat to use...
 
I really want a helmet exactly like this one. Ive seen others like it, but they don't have a donut as good as yours. I don't know where to start on the donut, where did you get the template for the donut?
 
Last edited by a moderator:
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top