In need of opinion.

The kit obviously does not come ready for ANYTHING. But with prep work,replacement of a few parts,and alot of work....it might be worth a risk.

The upper leg,hand,and elbow armor could be replaced with my more accurate pieces.
Supprisingly it got all positive feedback from the buyers.(wierd)

It would require:cutting,removing,glueing,and lots of prep work.(not to mention replacing said pieces)

Honestly,I am willing to take on this incredibly large challenge. I'm a big CT.net thread reader,and I think I can clean this mess up.
 
That palstic is as thin as paper in the pics. Take my advice DO NOT buy a kit from one of these crazy unknown of the wall makers. Save your money and get a set of OSCS,one stop clone shop, armor. I bought a kit I had reservations about and regretted it. I have since replaced almost every piece with OSCS armor.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top