Clone voice changer helmet mod

Array

New Hunter
Hi Guys haven't been here in a while

Ok so I got a Rex voice changer helmet and have been wondering how to make it look better, I think everyone knows what these look like but just in case

Photo0049.jpgPhoto0044.jpgPhoto0045.jpgPhoto0043.jpg
OK so I have not done much cos I don't now what to do, But I have cut up pieces of paper & pasted them on it, Now it looks like this
Photo0042.jpg
On the picture the visor may look a bit small but looks accurate in person.

Ok there are parts of the helmet I have some questions about, Please help.

Just to let you guys know I have not done anything like this before so please try to keep things simple, Thanks

Ok this part
Photo0046.jpg
As you can see it has cracks or lines that connects the helmet together, Ok question: What do I use to seal the cracks?
Photo0047.jpg
What about these cracks? Or that big air hole at the back? Those black lines at the bottom left are actually holes, are they supposed to be holes?
Photo0048.jpg
Is there supposed to be a wire mesh behind to mouth? & The mouth is supposed to be gray right?
Photo0050.jpg
Is that squire thing supposed to be wire mesh too? or does it look fine? If it is supposed to be wire how do I cut that squire out?
Photo0051.jpg
Is that round thingy correct? I know the is vent is supposed to be black but is the vent correct? those curves at the bottom are inaccurate right?

It came with a rangefinder that was a bit bent any ideas on how to fix that

And is it supposed to come with a cap for if I don't want the RF?

Well that's all I have for now, sorry if I sounded like I was ranting, if there's anything I missed please tell me

Oh yeah I don't like the paint job, so how do I remove the paint & should I remove it before or after I've modded It?

Thanks Guys appreciate the help
 
Good luck mate ive just started modding a hasbro bobba fett. I think that these helmets are good foundations especially if you are on a budget like me but need alot of work will be watchin your progress With interest!
 
dude i'd sand down the area in the face plate and get some plastic like garage sale signs, and use some bondo to harden it up. that's what im going to do for my helmet. ive also seen some tutorials online and youtube.
 
Last edited by a moderator:
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top