Clone trooper phase 1 armor

Niklasf95

New Hunter
Hello everyone,

I am a huge clone wars fan and really want clone wars armor(phase 1 armor with the fin on the helmet) I first thought about buying some armor but I couldn't really find anything. One thing I found was a website called: www.starfortressproductions.com but after reading that you should avoid them on various forums I was pretty much back to where I started. Then one of my friends said that he was making skyrim armor using hard foam(the kind thats used for the floor in gyms apparently) so I asked him about the clone trooper armor and he said that he could help me make it. I am just wondering should I make the clone trooper armor out of foam(which would cost about 100$ my friend sais)? Does anyone here know a place where I can get clone trooper armor? One more question: What would you recommend as a under suit for the armor?

Thank you very much!
 
Last edited by a moderator:
I am using Emfraa compression gear I ordered from Amazon. It's cheap, And it will still pass CRL guidelines without becoming too hot.
clone armor will be more than $100 but less than $700, FYI. It will be almost impossible to get foam armor passed by CRL if that's what you're aiming for.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top