WIP: Scratch-built gauntlets.

electric_jay said:
The sleeves are the plastic drnking cups, cut in half and hinged on one side...

Genius! That's a great idea. 8)

electric_jay said:
I think I met you at Dallas ComicCon last month. I was working the Madness table.

Nah, I couldn't make it out last month. I'm planning on being at the one this fall in Arlington though. :cheers
 
GAR Mando said:
Genius! That's a great idea. 8)

Thanks, man. it came ot me as I was trying to wake up yesterday morning and I started looking at my stainless steel travel mug. Too bad it was too small for my forearms.:p


Nah, I couldn't make it out last month. I'm planning on being at the one this fall in Arlington though. :cheers

Arlington, eh? My GFs brother (he owns Madness) will prolly ask me to work it, but I'm hoping to have my TIE Pilot done and be trooping for that one.
 
Flask? No...but that is a good idea to integrate into my costume somewhere.
:cheers

I am re-working them to look a little more "Mandalorian" while still not looking like Boba or Jango repaint. I'm leaving the right one alone for the most part.
 
Slim, you do realize this thread is 2.5 years old right? :rolleyes They don't keep pictures of everything on here forever.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top