Take 3

hmmm... that looks familiar... blue and green... hmmm... where have I seen that before? lol jk just givin' ya a hard time ner vod. Looks like u have a decent idea of what u want to do... which is good. Which helmet style r u going for?
 
well ya know there the standard Jango or Boba... then there's the MS Supercommando, Neo Crusader, Custombuilt, A'd'ika Supercommando, etc...
 
MY 200TH POST!!!!!!(y)(y)(y) :cheers Ok now I seem to have left my camera at school and im sick again:facepalm:( so i'll take some pics when i get it back. C'mon just hang in there guys:lol:
Jango 425
 
oh wait i can use mom's camera !! here ya go!!
359.jpg

362.jpg

360.jpg
 
? Im kinda confused with your question. If your asking if you should get bondo glass, that depends. If you are using just plain bondo like you are, you can just resin the helmet afterwards to give it the strength of bondo glass

not sure if that is what you asked
 
hi everyone
today me and dad went to wally world and i got some paint and another can for my cod,and knees and i dont know how to put the knee templates together i need some help please
 
First off when bonding remember less is more don't rush focus on one area at a time it will save you alot of frustration.

Second I found once the helmet was finshed (including the dome) out of cardboard or plastic. Paint on resin to the inside and out let that cure and then procede with the bondo.


good luck
 
same :D and good luck with that helmet, might want to round the dome of a little bit.

My advice is tape it from the inside to get it shaped nicely, just put tape on the tip
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top