My Bobba/Jango Costum

Apoes

New Hunter
all.. i had made my selv a nice armor, but it is only the front armor i made.. do som of you have som ideas?
Sorry Wrong place..'









 
I'd say judging from the first and last pics that it is probably sintra.

One thing you need to do though is prime it before painting. I'd also recommend spray painting or airbrushing over painting by brush. You'll also find it easier to heat and bend the sintra to shape BEFORE painting, that way you don't damage your paint job with bubbling and melting.
 
Did you freehand or use any sort of template? When it comes to painting, I would recommend that you sand it with a medium grit, then a high grit, then prime it. After that, you could then use spraypaints or airbrush. Also, I would recommend that you heat and form the material before you paint.

Good luck to you!
 
As Orthar and GCNgamer both said, form the armor before you paint it. You will thank us for telling you this =) If you use spray paint, your local auto supply store should have plastic spray handles that you can snap on the top of the cans. This will give you a more even spray.
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top