Mandalorian Merc Cannon Llats Ward build

MONR

New Hunter
Still on planning stage of my Llats but working on my other MMCC kit. Using a mix of Sintra and 3D print the armor is coming along ready for paint

8A9D93C3-E274-45F6-AC78-00400B9A37AB_zpsgz36uwkw.jpg
 

Attachments

  • 8A9D93C3-E274-45F6-AC78-00400B9A37AB_zpsgz36uwkw.jpg
    8A9D93C3-E274-45F6-AC78-00400B9A37AB_zpsgz36uwkw.jpg
    137.4 KB · Views: 312
I was looking at the knees and was not looking forward to rolling the edges to give it a bit more depth. Still they have performed quite well so far on my other kit.
 
Finally got a purchase on a bucket. And so it begins.
I have been looking at gauntlets and boots will be major purchases that will look the part. I have the WOF templates for the shin tools and will sintra them.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top