Another Newb

Thaxos

Jr Hunter
Hello, another new guy here. Been lurking around for a couple months now.
Last night I decided to print and cut out some of WoF's templates on some spare aluminum sheets I had.
Results:
http://s322.photobucket.com/albums/nn414/Thaxos/Aluminum Mando/
Not bad for a first try, in my opinion. I'm surprised the curves cut so nicely.
Not liking the cod piece though, tried shaping it and I am unhappy with the job I did...
I look forward to your advice/suggestions and spending more time on here!
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top