vaccu forming links

That instructable is for a tiny and lame vacuum former.

It's easy to make a much better one.

http://www.tk560.com/phpBB2/viewtopic.php?t=466
http://www.rcgroups.com/forums/showthread.php?t=621858
http://www.tk560.com/phpBB2/viewtopic.php?t=502

The vacuum forming forum on the tk560 discussion board is where it's at:

http://www.tk560.com/phpBB2/viewforum.php?f=1

BTW, it'd probably have been better to have bumped this earlier thread on the topic here on TDH:

http://www.thedentedhelmet.com/showthread.php?t=17010

Followups should probably go there so stuff doesn't end up scattered everywhere.
 
That instructable is for a tiny and lame vacuum former.

It's easy to make a much better one.

http://www.tk560.com/phpBB2/viewtopic.php?t=466
http://www.rcgroups.com/forums/showthread.php?t=621858
http://www.tk560.com/phpBB2/viewtopic.php?t=502

The vacuum forming forum on the tk560 discussion board is where it's at:

http://www.tk560.com/phpBB2/viewforum.php?f=1

BTW, it'd probably have been better to have bumped this earlier thread on the topic here on TDH:

http://www.thedentedhelmet.com/showthread.php?t=17010

Followups should probably go there so stuff doesn't end up scattered everywhere.


Lots of very good and quality information right there, I can promis you that

-tubachris
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top