Making a Silicone mold of a complex model with crossing limbs? Help!

saithbravo123

New Hunter
I have a model I would like to create a mold for, for strictly personal use of course. I've never made a mold but have researched it. However, this model (which I can't cut) has limbs that cross over the body in front and in the back and was hoping someone with experience could help me figure out how to make a 2 part mold for it? Thank you!
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top