Freddy Krueger Sculpt/Mask

Quick update, guys.
Just installed the zipper and it works pretty darn well. Here are some pics of me wearing it.

IMG_0131.JPG


IMG_0130.JPG
 
Finished the first couple coats of paint. It's still alittle drastic for my taste. I'm thinking about going over the whole thing with a wash of light orange to even it out.

For paint I used Elmer's rubber cement (a latex based adhiesive) thinned down and with alittle bit of acrylic paint. This way the paint just acts as another layer of latex, and flexes with the rest of the mask.

Sorry, didn't want to zip up the back for this pic.

IMG_0132.JPG
 
Nice to see this in all its completed glory, nice work my friend :). I think it needs "weathering" though, he looks far too clean and bright for a boiler-room dwelling child murder :D.
 
Working on a new glove. I'm using real copper this time. Running into alot of the some problems, though, with joint stiffness:facepalm.

I took another picture, but TDH won't let my upload it:facepalm:facepalm

Picture 031.jpg
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top