District 9 weapons

dung0beetle

Active Hunter
I'm modeling all of the District 9 weapons (that I can get ref. pics of) to be made into pepakura files or possibly cnc milled. I am wondering how detailed I need to make them. If I do it too detailed, it will be impossible to pep, but if it is not detailed enough, there will be lots of postwork after it is cnc milled.
I am starting with the gasthrower. It didn't get much screen time, but I like the look of it.

533AlienGasThower4finGB.jpg


gasthrowerwip1.gif


gasthrowerwip2.gif
 
Last edited by a moderator:
That would be cool. I was thinking building D9 weapons would be pretty cool when watching it. Alas, I don't think my building skills are up to the challenge atm.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top