Blast Damage

Eht Eno

Hunter
Anyone know how to make it look moer smokey. I have tried ink/water method looks more like watercolor. Even used a dropper to make sure it was 1/1, water to ink. But it did work well for my weathering. LOL Now all I need is some fool proof way to do blast damge properly.

-dan-
 
I grinded down a charcoal stick with sandpaper and applied it with a old paintbrush.It seemed to work prety well.I think I need some more practice with it though.I would like to know if there are any other methods out there too.
 
I achieve my blast damage with an airbrush and sponging on with watered down acrylics. It took some practice to get it the way it should look and I'm happy with the results.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top