Ao2 Mask, Criticism wanted

MandoMan

Active Hunter
I'm not sure when I'll be able to afford one of Jarvis' beautiful Ao2 masks, so I decided to try my hand at sculpting one myself. I've never sculpted a thing in my life before this, so it's more than a little rough, and proportions are off. It looks a little too tall and skinny, but I'm too much of a wuss to widen it and I don't have enough clay anyways. :p

Any criticism? Or maybe some tips on ways to get it smoothed and ready for molding, assuming that I get that far?

riosmasksculpt2.jpg


riosmasksculpt3.jpg
 
it looks like the left (the unfinished one) eye socket is a goes down lower than the one on the right side but other than that it looks like its coming along rather nicely:)
 
I completely forgot about this thread. :lol:

Thanks Mitch!

I do have an updated picture to add. This is pretty much the final look, although I did redo the "teeth damage". Just need to get some silicone and mold it up. :)

tysonriosmask.jpg
 
I built one of the Ao2 masks, and theres a blank template to use as a reference, Ill post when I can find it. Also, one thing I noticed, the nose bridge looks a bit profused...
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top