Air Bubble Filler

jedi paramedic

Active Hunter
I was wondering what everyone uses to fill in the small air bubbles you find on your Helmets or Armor. I used some bondo on some of them, but it didn't fill them completely and I keep sanding down to find the same holes. I'm not sure if there is some kind of putty that would be easier to use.
 
I've used plain ol' modeling putty on small air bubbles and it has worked fine.
Any model shop should carry brands like Tamiya or Squadron.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top