ABS WITH FIBREGLASS

BANDITZ

Hunter
Just bought a ABS trooper lid.... if i use fibreglass to re-line the interior will it react with the ABS......any help please..... :confused
 
I think it may warp it a little unless you have a low temp catylist. But I don't really know that much about fiberglass or resin so maybe someone else familiar with it can chime in.
 
normal polyester resin should work..doesn't heat up or anything.. but will give you one heck of a buzz if not in a ventilated room or facemask.
 
I second that. Do it outside.

Some automotive body repair fiberglass sheets have a low temp cure. You might try that.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top