Quick and Dirty Jango Gauntlet LED Wiring Tutorial

Foxbatkllr

Well-Known Hunter
This is a quick and easy way to power your left gauntlet LED with the accurate slide switch. I suck at soldering and wiring. This is about as complicated as I can get, so if I can do it you can do it. The battery pack fits conveniently inside my flamethrower box. Certainly someone with more experience could figure out a more space saving method of powering the LED. But this is what I went with since it was cheap and easy and available at Radioshack.

2251585192_fcc0474b94_o.jpg


2251585194_b638d2b26f_o.jpg
 
I used a similar method on mine, but I used a kids LED flashlight available through AVON. ( it's the style that can be operated by battery or by a pump handle )

I narrowed/streamlined the unit down from the 5 LEDs to one, and removed one of the two watch batteries to dim/lower the brightness of the LED. It all fits nicely inside the gauntlet. (y)

IMG00478.jpg

IMG00479.jpg

IMG00471.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top