noob questions about the helmet

ok cool i have a flex shaft, did not consider using it,but i will give it a shot on a practise helm i bought for cheap. and the engraving cutter is what i used to cut out the key slots on that practise helm, i will go and check out the hacksaw and hand files. thanks guys
 
Last edited by a moderator:
the only thing i don't cut with the dremel 111 is the excess flash that you sometimes get around the base of the helmet. that i use a fiberglass cutoff wheel. but everything else, dremel 111.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top