INTEREST: Aluminum Jango Blasters

Mike M.

Well-Known Hunter
Community Staff
TDH PREMIUM MEMBER
so my boys at the machine shop would like to do a run of jango blasters. they've been using my set of blasters for all their reference so far, which i believe to be a pair of master replica prototypes. now these aren't going to be cheap, but they will be less than what MR's are going for these days; a rough estimate is that they will be around $600/pair. i'll need at least 20 to make this happen, and will be able to handle more if there's that much interest.

here's the cad drawings of whats done so far.

GunAppearance.jpg


i think they've cadded up the handle, i just don't have the pic of that yet. also i have a few pieces prototyped as well, i just don't have handy pics of those either. so would anyone like these?
 
I think this was a great I idea. Come holiday or tax time, I think this project would do well. People's wallets seem to be pretty tight right now. If these would look anything remotely near a MR Westar, I'd love to have an extra set.
 
if anyone wants, i can post pics of the protyped pieces and a shot of the blaster that the measurements are being taken from.
 
I think this was a great I idea. Come holiday or tax time, I think this project would do well. People's wallets seem to be pretty tight right now. If these would look anything remotely near a MR Westar, I'd love to have an extra set.

I'll second that. Timing is just bad.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top