Hyper foam jet pack

Hyper foam jetpack

I was wondering how many of you would like to see a hyperfoam jet pack?

Please post if you would like one.
This is not a run! I just looking into how if it is worth my time to start a run. I will update the thread if this becomes a run.
FYI
Hyperfoam, is the same foam as E-11 blasters. They do not break apart as fiberglass and styrene. The can take the abuse and keep trooping.
Cheers
Rob
 
Do you mean hyperfirm?

What type of jet pack (Arean or Kamino) - how well do these hold paint?
 
Last edited by a moderator:
Wouldn't it end up costing like $800 since blasters which require smaller molds and a much smaller volume of product cost around $400? I'd have questions too about just how well it would hold all the various paints and how the seams would be dealt with. All the blasters made from hyperfirm that I have seen in person have seams, which are not that noticeable only because the blasters are black.
 
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top