Thoughts on 3D Prints

Gaheris

New Hunter
Hey guys,

So i started my scratch build last week and have got to the filler / fibreglass point. Turns out my brother's best mate has a large 3D Printer so i was wondering what the thoughts are on 3D printed helmets and parts and are they sturdy / durable?

(Edited as I found Rafal's £D Project Files)
 
Last edited by a moderator:
depends on the printer quality. For some small pieces it won't be perfect but still fair enough and even better than a cardboard build. You will have to sand and bondo too with most printers though.
It will work like charm for the biggest pieces imo.
 
Can take a while and use a lot of filament, Also annoying if the print messes up near the end.

But yeah, if you have one, use it. Nothing beats them for rapidly prototyping an object that you can hand-finish later. It's pretty much just skipping the template construction steps and going directly to the sanding and finishing.
 
So far I have not found a good one to even print unless you want to spend a little money on the files. I have tried several from different sites and so far none have impressed me yet and I've waited A LOT of filament.
The plus side would be weight though. My scratch built helmet weighs a bit but the 3D printed ones I have weigh nothing.
For the record, if anyone has a good helmet file I can have to print, get with me!!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top