T-visor question

aguma

Hunter
i just bought a don post 96 (i know, it sucks) and i was wonderin what to do with the visor...of course i immidiately got rid of the first one and ive traced out the size the visor should be, but i was wondering...should i cut the plastic all around it and just get a much bigger piece and perhaps glue or tape it to the inside of the helmet, or leave it and glue or tape it to the outside area? please help T _ T
 
T _ T is an anime-ish face thingy lol like these: o . o o _ o x _ x xD :D T _ T @ . @ they are all just faces lol sorry for the confusion

also, how would i go about in cutting it? i dont want to dammage it anymore then it is, seeing as how it already has 3 tears and i had to stick it in the oven and shape it back because it was so bent i couldnt put it on...its pretty good now though
 
Thanks for the clarification on the smilies!:lol:lol::lol:

Anyway, I would use a ruler and an exacto knife, but you have to be careful and go slow while cutting it. After you have cut it, it may be a good idea to sand away any sharp edges that may remain.
 
oh and i was wondering what i should use as the actuall visor...because the window tint i looked at is basically a big sticker...and i cant find anything like thin-transparent plastic to stick it on...what did everyone here use for visors?
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top