Rangefinder LED activation when lowered?

yodakiller1138

Well-Known Hunter
My stalk will have a RC servo to lower up and down. I want the LED's in the rangefinder to activate when it is in the lowered position. Anyone have any ideas to how I would go about doing this?
 
The lights need to be on a tilt switch or a mercury switch. It's been done many times and documented here. Just do a search for rangefinder lights and I'm sure it will come up. You seek mrgr8ness or salamanderking.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top