RangeFinder help

ryan101011

Jr Hunter
I'm currently working on my rangefinder for my esb fett, and ive (after a long while) tracked down the circuitry for it, the stalk and topper that came along with the helmet I bought are just solid orange 3D printed parts, would anyone be so kind as to point me to where I might be able to get a stalk and topper that is hollow?
Thanks, Ryan
 
thx rafal,
will give them a look, initially used your templates to try and scratch build it, turns out I'm not the most talented at arts and crafts.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top