My Helmet arrived today

it's been a while since i've seen a vac formed helmet. i want to say it's a bradleyfett. it doesn't look too difficult to assemble from the pictures. though it doesn't show anything about the dent, or even if it comes with a resin dent to add in later. if you got a dent from another helmet i'm sure you could easily make up a template similar to the turn signals and cut it in yourself.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top