Mandible Thickness?

N

no good to me dead

New Hunter
TK 409 hasen't specified a thickness for the mandibles
I was concidering using 1/8 inch Styrene for them but is that too thick?
This picture looks like it might be... what are your guys thoughts?

PS... thanks AFFO$ for the great picture

untitled.JPG
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

clmayfield
Mandible Red Paint Comparison
Replies
11
Views
2,509
clmayfield
clmayfield
clmayfield
Color Mix Nerds: ESB Mandibles?
Replies
10
Views
4,070
Builder
Builder
Searay758
Preventing Mandible Spread?
Replies
3
Views
1,483
Necronaut
Necronaut
Jayvee
ESB Mandible red
Replies
10
Views
3,007
Jayvee
Jayvee
Hellhounds
I NEED HELP! mandible issue
Replies
4
Views
2,106
Hellhounds
Hellhounds

Similar threads

clmayfield
Mandible Red Paint Comparison
Replies
11
Views
2,509
clmayfield
clmayfield
clmayfield
Color Mix Nerds: ESB Mandibles?
Replies
10
Views
4,070
Builder
Builder
Searay758
Preventing Mandible Spread?
Replies
3
Views
1,483
Necronaut
Necronaut
Jayvee
ESB Mandible red
Replies
10
Views
3,007
Jayvee
Jayvee
Hellhounds
I NEED HELP! mandible issue
Replies
4
Views
2,106
Hellhounds
Hellhounds
Back
Top