Keyslot help

Byyynik

Hunter
I am not sure what is the best way to cut out the keyslots in the back i have the squares cut but the slits are driving me crazy any advise. my drimmel's cutting wheel wont fit
 
I use a small drill bit to make a series of holes in the thinner parts, then carefully drag the drill bit sideways to clear out most of the material.
I finish with some small jewelers files.
 
Sweet thnx for the help guys not i need to work on my spray painting i seem to over spray and get drips down the helmet. i guess i need to sand and redo and just mist it till its done. I will post more picks on my helmet thread
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top