Jango helmet changes in boba

Cobtrooper

New Hunter
Hi Everyone,

Here I begin my Boba

The kit come from a friend is a Jango.

The humpback is not the right place and it's missing the piece on the cheek.

bkbt3.jpg

bkbt1.jpg



Here are my changes.

Remove the bump

bkbt5.jpg


creation of small button on the side of the cheek of the helmet.

bkbt7.jpg

bkbt8.jpg


Then I repeated the bump on the front of the helmet as Boba.

bkbt6.jpg

bkbt9.jpg


And a profile.

bkbt10.jpg


Your opinion?

ps: sorry for my bad english :)
 
Nice progress... the dent seems to be a little high tho?

just MO - It's a shame you had to mod a decent Jango lid to do it
 
yikes! well, it's too late now, but you could have sold that for more than enough to get a nice boba...

the dent is a bit high, as others have mentioned. compare:

normal_FETT_C4_Helmet_-_094.jpg
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top