Help

Er, your questions at the top?

"I have a problem with this" & "How do I connect to (picture 4)? How do I deflect this (picture 5)"

Do you mean how to connect the cheek pieces into the mandible sections?
 
The page that you say, is the basic shape of the helmet if you see it at the bottom. You don't need to cut it, only be sure that your bucket has this shape ;)

:cheers
 
The page that you say, is the basic shape of the helmet if you see it at the bottom. You don't need to cut it, only be sure that your bucket has this shape ;)

:cheers

Oh, thanks.

Now I only cut the aluminum?

...

I'm going. Then see whether someone has written something
Thanks
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top