GMH sizing differences?

slave1pilot

Well-Known Hunter
I have owned both the Fiberglass GMH and the resin GMH helmets that Fettpride has been offering.
The Fiberglass fit fine, however the resin atrocity will not even fit over my head.
anyone else experience a sizing difference?

Is it because the resin is soooo thick, or is it an actually shrinkage issue?
 
Nate,
I havent been able to size the fiberglass version, but I can say for certain that the resin GMH does not fit my head either. I wear a 7 3/8 hat so I was a bit surprised it didnt fit....
 
for comparison
Here's my Fiberglass MR Premium on the left, and the fiberglass GMH in the middle, and the Resin GMH on the right.

comparebuckets3.jpg


comparebuckets3.jpg


Granted, these were taken months apart (and I did lose 25 lbs since the first 2 pics were taken), but it's obvious that there's a slight problem.

That's as far as the helmet will go on.
*insert "big-head" jokes here if you must*
 

Attachments

  • comparebuckets3.jpg
    comparebuckets3.jpg
    131.7 KB · Views: 124
Last edited by a moderator:
It is probably like a pair of blue jeans, just think positive and force it on.....it will loosen up....




sarcasm of course
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top