Casting a fibreglass helmet! help!

S

slave driver

Guest
Hi there everyone,

I’m thinking of modelling and casting my own bucket in fibreglass. Does anyone have any advice of the number of parts to cast the helmet in? My ST bucket is in three parts (front, back and Dome) is this the best way or could I get away with two?!

Thanks in advance for the help

Ash
 
most of the recast here are made in two parts front and back, or use a mold with front and back, im not an expert, but check with the search tool im sure u can find what you lookin :)
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top