MR Blaster owners, need your help!!!

Lucksy31

Well-Known Hunter
Preferred Vendor
I'm trying to have a custom display case made, modeled after the display case that comes with your MR balster. I Have the measurements for the actual case, but I do NOT have the measurements for the (2) brackets that hold up the blaster inside the case. Would anyone who has one, be able to measure the (2) brackets for me? Length, Width and Height?


MR_Case_zps73d25a6c.jpg


Thank you!!!

-Scott
 
Using your measurements and some images from other online sources, I managed to do these drawing:

MR EE-3 Blaster Supports.jpg

And here are the A4 and LTR files to print it in full scale:

MR ROTJ EE-3 Blaster Supports A4.jpg MR ROTJ EE-3 Blaster Supports LTR.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top